Page 1 of 1
Installing IEGD 10.3.1
Posted: Mon May 31, 2010 5:12 pm
by Stough
I attempted to install IEGD 10.3.1 under XP SP3 by running Utilities\Setup. However, each time I got
"All the components are not installed correctly. Please try installing again"
What is the correct way to install this driver?
Re: Installing IEGD 10.3.1
Posted: Tue Jun 01, 2010 7:45 am
by Leonid
Hi.
Before you install the IEGD, you have to uninstall the previous video driver.
Re: Installing IEGD 10.3.1
Posted: Fri Jun 04, 2010 5:13 pm
by Stough
Thanks for your reply.
I tried to install IEGD 10.3.1 again. This time I ran setup from the utility directory, and said yes to un-install the current driver. This seemed to work. However, when I ran setup again to install the new driver I got the same error about components not being installed. Also, when I rebooted XP came up in a very low resolution mode. The system noticed that there was no video drive, and downloaded one (from Intel?).
Am I missing something about how to install IEGD 10.3.1?
Bruce
Re: Installing IEGD 10.3.1
Posted: Fri Jun 04, 2010 11:54 pm
by Leonid
Hi.
We need more information about your system in order to reconstruct the problem:
1. fit-PC2 revision.
2. BIOS date.
3. Did you get the fit-PC2 with preinstalled WinXP?
Re: Installing IEGD 10.3.1
Posted: Sun Jun 06, 2010 9:51 pm
by Stough
Leonid,
1. My unit is revision 1.21, not the new 1.4
2. The bios date is 12/24/09
3. I bought it without a disk, and installed XP Pro myself
Thanks for looking into this.
Bruce
Re: Installing IEGD 10.3.1
Posted: Thu Jun 10, 2010 12:02 pm
by Leonid
Hi.
I cann't reproduce the problem.
I installed the IEGD driver successfully on the fit-PC2 rev 1.21 with WinxXP Pro SP3.
Here my test scenario:
1. Install WinXP Pro
2. Install SP3
3. Install chipset driver
4. Install IEGD