Difference between revisions of "Airtop3 I3M firmware update"
From fit-PC wiki
(→Updating the firmware) (change visibility) |
|||
(One intermediate revision by the same user not shown) | |||
Line 1: | Line 1: | ||
== Download == | == Download == | ||
− | Download Airtop3 [https://fit-iot.com/files/download/airtop3/sw/I3M/Firmware/i3mrescuedisc. | + | Download Airtop3 [https://fit-iot.com/files/download/airtop3/sw/I3M/Firmware/i3mrescuedisc.zip I<sup>3</sup>M firmware update image] |
== Installation instructions == | == Installation instructions == | ||
Line 23: | Line 23: | ||
#Plug the prepared USB drive into the target Airtop3. | #Plug the prepared USB drive into the target Airtop3. | ||
#Hold the left and right buttons on the I<sup>3</sup>M and plug in the power supply. Keep holding the buttons until the I<sup>3</sup>M reports it is in ''bootloader'' mode. | #Hold the left and right buttons on the I<sup>3</sup>M and plug in the power supply. Keep holding the buttons until the I<sup>3</sup>M reports it is in ''bootloader'' mode. | ||
− | #Reboot and enter BIOS menu by pressing '''[ | + | #Reboot and enter BIOS menu by pressing '''[ESC]''' repeatedly upon startup |
#Navigate to boot tab and '''[Enable]''' UEFI internal shell | #Navigate to boot tab and '''[Enable]''' UEFI internal shell | ||
#Navigate to Save&exit tab to save changes & exit. | #Navigate to Save&exit tab to save changes & exit. |
Latest revision as of 14:58, 31 December 2019
Contents
Download
Download Airtop3 I3M firmware update image
Installation instructions
Preparing a bootable USB flash device on Windows
- Unzip the image to obtain the i3mrescuedisk image.
- Download the Passmark ImageUSB application
- Run the imageUSB.exe file.
- Select the destination USB drive.
- Select the 'Write image to USB drive' option.
- Select the i3mrescuedisk file.
- Click the 'Write' button to begin the image flashing.
WARNING: The contents of the selected drive will be replaced. It will cause destruction of the previous data and possible loss of capacity.
Preparing a bootable USB flash device on Linux
- Unzip the image to obtain the i3mrescuedisk image. This can be done with the command: unzip i3mrescuedisk.zip
- Plug a USB drive into a Linux workstation. The OS will detect and name the drive something like /dev/sdX. You can use the following command to get the name of the USB drive: dmesg | tail
- Write the i3mrescuedisk image to the USB drive using dd command: dd if=i3mrescuedisk of=/dev/sdX; sync
Updating the firmware
- Power off Airtop3 and unplug the power supply.
- Plug the prepared USB drive into the target Airtop3.
- Hold the left and right buttons on the I3M and plug in the power supply. Keep holding the buttons until the I3M reports it is in bootloader mode.
- Reboot and enter BIOS menu by pressing [ESC] repeatedly upon startup
- Navigate to boot tab and [Enable] UEFI internal shell
- Navigate to Save&exit tab to save changes & exit.
- Upon reboot, enter the boot menu by pressing [F7] on startup.
- Select UEFI Internal shell. The system will boot into the I3M recovery tool.
- Wait until the recovery tool reports: "Front panel firmware was updated successfully!".
- Press Enter to reboot.