Difference between revisions of "FACE Modules:FM-SER"
From fit-PC wiki
(→Highlights) (change visibility) |
(→Highlights) (change visibility) |
||
| Line 18: | Line 18: | ||
! style="font-weight: bold;" | Specifications | ! style="font-weight: bold;" | Specifications | ||
|- | |- | ||
| − | | RS232 / RS485 / | + | | RS232 / RS485 / RS422<sup>1</sup> |
| − | | 6x RJ-11 jacks functioning as | + | | 6x RJ-11 jacks functioning as RS232<sup>2</sup>, as half<sup>3</sup>/full-duplex RS485 or RS422 serial ports; |
|- | |- | ||
| CAN bus | | CAN bus | ||
Revision as of 11:16, 8 September 2015
Contents
FM-SER Module
FM-SER FACE Module provide various serial connectivity solution and compatible with several Compulab systems. Refer to Compatibility Matrix for products fit.
Highlights
- High performance UARTS
- Asynchronous baud rates up to 15Mbps
- 128-byte deep TX/RX FIFOs
- Advanced FIFO fill management
- RS232, RS485, RS422 operation
- Programmable RS485 turn-around delay
- 450 through 950 software compatibility
- Two independent CAN bus controllers implement CAN V2.0B at rate of up to 1Mbps each
- Isolated PHY with rated isolation voltage of 2.5 kV RMS
| Connectivity | Specifications |
|---|---|
| RS232 / RS485 / RS4221 | 6x RJ-11 jacks functioning as RS2322, as half3/full-duplex RS485 or RS422 serial ports; |
| CAN bus | 2x RJ-45 jacks functioning as an isolated Controller Area Network (CAN) bus |
Notes:
- The default standard can be configured by jumper E1. See section Serial Ports Configuration.
- FM-SER is classified as DTE (Data Terminal Equipment) in terms of RS232 standard definition.
- RS485 half-duplex mode requires special HW/SW adaptation
Block Diagram
Schematics
Layout
Mechanics
Assembly
