Difference between revisions of "Fit-PC4 Errata Notes"
From fit-PC wiki
| Line 1: | Line 1: | ||
| − | == | + | == FITPC4ERR001: Power LED == |
| − | + | * '''Date''': | |
| − | + | * '''Symptom''': Power (Logo) LED enabled at all power states (S0, S3, S4 and S5), even during SW shut down | |
| − | * ''' | + | * '''Applies to revision(s)''': 1.0 to 1.1 |
| + | * '''Cause''': Incorrect LED connection | ||
| + | * '''Workaround''': Ignore logo LED indications | ||
* '''Fix''': Fixed in revision 1.2 | * '''Fix''': Fixed in revision 1.2 | ||
| − | + | == FITPC4ERR002: Memory organization == | |
| − | + | * '''Date''': | |
| − | * ''' | + | * '''Symptom''': When single memory module installed on inner slot (P6) it may cause the system not to pass memory initialization |
| − | * ''' | + | * '''Applies to revision(s)''': 1.0 to 1.1 |
| − | + | * '''Cause''': Incorrect SIM slot pin routing | |
| + | * '''Workaround''': In case single SO-DIMM to be used, it should populate the slot closer to PCB edge (P7) | ||
| + | * '''Fix''': Populate the slot closer to PCB edge (P7) | ||
[[category:fit-PC4]] | [[category:fit-PC4]] | ||
Revision as of 10:08, 11 October 2015
FITPC4ERR001: Power LED
- Date:
- Symptom: Power (Logo) LED enabled at all power states (S0, S3, S4 and S5), even during SW shut down
- Applies to revision(s): 1.0 to 1.1
- Cause: Incorrect LED connection
- Workaround: Ignore logo LED indications
- Fix: Fixed in revision 1.2
FITPC4ERR002: Memory organization
- Date:
- Symptom: When single memory module installed on inner slot (P6) it may cause the system not to pass memory initialization
- Applies to revision(s): 1.0 to 1.1
- Cause: Incorrect SIM slot pin routing
- Workaround: In case single SO-DIMM to be used, it should populate the slot closer to PCB edge (P7)
- Fix: Populate the slot closer to PCB edge (P7)
