Difference between revisions of "IPC2B: USB3.0 Driver Installation Guide"

From fit-PC wiki
Jump to: navigation, search
 
(2 intermediate revisions by the same user not shown)
Line 17: Line 17:
 
7. Enter the BIOS menu by pressing the '''[F2]''' key during boot
 
7. Enter the BIOS menu by pressing the '''[F2]''' key during boot
  
8. Browse to
+
8. In the BIOS menu browse as follows:
   Advanced
+
   >Advanced
     South Bridge Configuration
+
     >>South Bridge Configuration
         '''SB USB Config''' Menu.  
+
         >>'''SB USB Config''' Menu.  
        set '''xHCI Mode''' to '''[Enabled]'''
+
        *set '''xHCI Mode''' to '''[Enabled]'''
 
9. Press the '''[F10]''' key for Save&Exit
 
9. Press the '''[F10]''' key for Save&Exit
  

Latest revision as of 06:32, 16 October 2018

  • This application note provides a step by step guide to install USB3.0 drivers over Windows 7.
  • Applicable to IPC2-Broadwell machines.

Instructions

1. Install the Chipset driver before the USB3.0 driver

2. Download the USB3.0 driver

3. Extract the downloaded package

4. Run the OfflineSetup32.exe file for Windows 7 32bit or the OfflineSetup64.exe file for Windows 7 64bit

5. Follow the on-screen instructions

6. At the the end of installation process, reset the unit

7. Enter the BIOS menu by pressing the [F2] key during boot

8. In the BIOS menu browse as follows:

  >Advanced
    >>South Bridge Configuration
       >>SB USB Config Menu. 
        *set xHCI Mode to [Enabled]

9. Press the [F10] key for Save&Exit

10. When Windows boots up, open the downloaded package

11. Run the Setup.exe file

12. Follow the on-screen instructions

13. At the the end of installation process, reset the unit