Difference between revisions of "IPC2B: USB3.0 Driver Installation Guide"

From fit-PC wiki
Jump to: navigation, search
Line 1: Line 1:
 
* Install the Chipset driver before the USB3.0 driver
 
* Install the Chipset driver before the USB3.0 driver
 
* Download the [http://fit-iot.com/files/download/intense-pc2/sw/drivers/win7/IPC2_BDW_Win7_USB30.zip USB3.0 driver]
 
* Download the [http://fit-iot.com/files/download/intense-pc2/sw/drivers/win7/IPC2_BDW_Win7_USB30.zip USB3.0 driver]
* Run the '''OfflineSetup32.exe''' for Windows 7 32bit or the '''OfflineSetup64.exe''' for Windows 7 64bit
+
* Open the donloaded package
 +
* Run the '''OfflineSetup32.exe''' file for Windows 7 32bit or the '''OfflineSetup64.exe''' file for Windows 7 64bit
 
* Follow the on-screen instructions
 
* Follow the on-screen instructions
 
* At the the end of installation process, reset the unit
 
* At the the end of installation process, reset the unit
* Enter the BIOS menu by pressing the F key during the boot
+
* Enter the BIOS menu by pressing the '''F2''' key during the boot
 
* Browse to the '''Advanced -> South Bridge Configuration -> SB USB Config''' menu and set the '''xHCI Mode''' setting to '''Enabled'''
 
* Browse to the '''Advanced -> South Bridge Configuration -> SB USB Config''' menu and set the '''xHCI Mode''' setting to '''Enabled'''
* Press the F10 key for Save&Exit
+
* Press the '''F10''' key for Save&Exit
 +
* When the Windwos boot up, open the donloaded package
 +
* Run the '''Setup.exe''' file
 +
* Follow the on-screen instructions
 +
* At the the end of installation process, reset the unit

Revision as of 07:44, 14 October 2018

  • Install the Chipset driver before the USB3.0 driver
  • Download the USB3.0 driver
  • Open the donloaded package
  • Run the OfflineSetup32.exe file for Windows 7 32bit or the OfflineSetup64.exe file for Windows 7 64bit
  • Follow the on-screen instructions
  • At the the end of installation process, reset the unit
  • Enter the BIOS menu by pressing the F2 key during the boot
  • Browse to the Advanced -> South Bridge Configuration -> SB USB Config menu and set the xHCI Mode setting to Enabled
  • Press the F10 key for Save&Exit
  • When the Windwos boot up, open the donloaded package
  • Run the Setup.exe file
  • Follow the on-screen instructions
  • At the the end of installation process, reset the unit