Difference between revisions of "IPC2B: USB3.0 Driver Installation Guide"

From fit-PC wiki
Jump to: navigation, search
Line 1: Line 1:
 +
* This application note provides a step by step guide to install USB3.0 drivers over Windows 7.
 +
* This guide is applicable to IPC2-Broadwell machines.
 +
 +
==Instructions==
 
* Install the [http://fit-iot.com/files/download/intense-pc2/sw/drivers/win7/IPC2_BDW_Win7_Chipset.zip Chipset driver] driver before the USB3.0 driver
 
* Install the [http://fit-iot.com/files/download/intense-pc2/sw/drivers/win7/IPC2_BDW_Win7_Chipset.zip Chipset driver] driver before the USB3.0 driver
 
* Download the [http://fit-iot.com/files/download/intense-pc2/sw/drivers/win7/IPC2_BDW_Win7_USB30.zip USB3.0 driver]
 
* Download the [http://fit-iot.com/files/download/intense-pc2/sw/drivers/win7/IPC2_BDW_Win7_USB30.zip USB3.0 driver]
Line 12: Line 16:
 
* Follow the on-screen instructions
 
* Follow the on-screen instructions
 
* At the the end of installation process, reset the unit
 
* At the the end of installation process, reset the unit
 +
 +
[[Category:IPC2]]
 +
[[Category:software]]
 +
[[Category:Application notes]]

Revision as of 13:41, 15 October 2018

  • This application note provides a step by step guide to install USB3.0 drivers over Windows 7.
  • This guide is applicable to IPC2-Broadwell machines.

Instructions

  • Install the Chipset driver driver before the USB3.0 driver
  • Download the USB3.0 driver
  • Open the donloaded package
  • Run the OfflineSetup32.exe file for Windows 7 32bit or the OfflineSetup64.exe file for Windows 7 64bit
  • Follow the on-screen instructions
  • At the the end of installation process, reset the unit
  • Enter the BIOS menu by pressing the F2 key during the boot
  • Browse to the Advanced -> South Bridge Configuration -> SB USB Config menu and set the xHCI Mode setting to Enabled
  • Press the F10 key for Save&Exit
  • When the Windwos boot up, open the donloaded package
  • Run the Setup.exe file
  • Follow the on-screen instructions
  • At the the end of installation process, reset the unit