IPC2B: USB3.0 Driver Installation Guide

From fit-PC wiki
Revision as of 13:50, 15 October 2018 by Tamir (Talk | contribs)

Jump to: navigation, search
  • This application note provides a step by step guide to install USB3.0 drivers over Windows 7.
  • Applicable to IPC2-Broadwell machines.

Instructions

1. Install the Chipset driver before the USB3.0 driver 2. Download the USB3.0 driver 3. Extract the downloaded package 4. Run the OfflineSetup32.exe file for Windows 7 32bit or the OfflineSetup64.exe file for Windows 7 64bit 5. Follow the on-screen instructions 6. At the the end of installation process, reset the unit 7. Enter the BIOS menu by pressing the [F2] key during boot 8. Browse to

  Advanced
    South Bridge Configuration
       SB USB Config Menu. 
       set xHCI Mode to [Enabled]

9. Press the [F10] key for Save&Exit 10. When Windows bootd up, open the downloaded package 11. Run the Setup.exe file 12. Follow the on-screen instructions 13. At the the end of installation process, reset the unit