Difference between revisions of "Quick AMT Setup"
From fit-PC wiki
Line 19: | Line 19: | ||
**IPC2 - LAN1 | **IPC2 - LAN1 | ||
**Intense PC - LAN closer to the edge | **Intense PC - LAN closer to the edge | ||
+ | **uSVR - LAN closer to the edge | ||
*On the remote machine: | *On the remote machine: | ||
− | **Open browser and set address to http:// | + | **Open browser and set address to http://''your IP address'':16992 when "your_ip" was set previously in the AMT setup |
**Press "Log On" and enter login/password -> "admin"/your_psw when "your_psw" was set previously in the AMT setup | **Press "Log On" and enter login/password -> "admin"/your_psw when "your_psw" was set previously in the AMT setup | ||
**Now all system information/status/remote management menus are accessible including remote power on/off | **Now all system information/status/remote management menus are accessible including remote power on/off | ||
*For remote KVM use "VNC Viewer Plus": http://www.realvnc.com/products/viewerplus/ | *For remote KVM use "VNC Viewer Plus": http://www.realvnc.com/products/viewerplus/ |
Revision as of 10:13, 7 February 2017
Quick AMT Setup
- Enter BIOS go to ADVANCED -> AMT Configuration and set "Enter Intel(R) MEBx Setup" to "Enabled"
- Exit saving changes -> System will boot ( one time ) to MEBx AMT setup
- Enter "MEBx Login" -> using password "admin" and set the "Intel(R) ME New password " according with rules below
- At least 8 characters ( max32)
- At least one digit character(0-9)
- At least one 7-bit ASCII non alpha-numeric character(e.g.'!','$',';') , but excluding ':' ,',' and '""' characters
- At least one lower case letter ('a','b'...'z') and at least one upper case letter ('A' ,'B'...'Z')
- Enter "Intel(R) Standard Manageability Configuration" -> "Activate Network Access" and press "Y"
- Enter "Network Setup" -> "TCP/IP Settings" ->"Wired LAN IPV4 Configuration" -> "DHCP Mode" and set to "Disabled"
- Now set all IPs related settings and then press "ESC" four times - returning to main menu
- Press "MEBx Exit" and wait until reboot
- Unplug your system for 20-30s and then plug it back
Usage
- Connect AMT capable LAN port to a network:
- Airtop - LAN2
- IPC2 - LAN1
- Intense PC - LAN closer to the edge
- uSVR - LAN closer to the edge
- On the remote machine:
- Open browser and set address to http://your IP address:16992 when "your_ip" was set previously in the AMT setup
- Press "Log On" and enter login/password -> "admin"/your_psw when "your_psw" was set previously in the AMT setup
- Now all system information/status/remote management menus are accessible including remote power on/off
- For remote KVM use "VNC Viewer Plus": http://www.realvnc.com/products/viewerplus/