Auto Power on

Post Reply
favel
Posts: 1
Joined: Thu Jul 31, 2014 3:22 pm

Auto Power on

Post by favel »

Is it possible to deactivate auto power on?
I would even desolder a transistor (like I did with a fit pc2)

mbirger

Re: Auto Power on

Post by mbirger »

IPC2 BIOS allows to configure auto on behavior. Refer to the image below:
Go to Advanced -> South Bridge Configuration -> State after G3.
Set the power state that will be applied after power is resumed:
S5 - Shut down
S0 - Active

Image

Post Reply

Return to “IPC2 Hardware”