Page 1 of 1

Operating a Fit PC 2 without a Monitor

Posted: Thu Apr 21, 2011 1:32 am
by yiyangli
I need to use the Fit PC 2 for a robotic application, so I cannot mount a monitor. The computer I bought will not power on unless it's connected to a monitor using DVI. It will automatically shut off if I disconnect the monitor or the DVI port. Turning the monitor off, however, still allows the Fit PC 2 to run.

Any suggestions on how to run the Fit PC 2 without a monitor?

Re: Operating a Fit PC 2 without a Monitor

Posted: Fri Apr 22, 2011 7:07 am
by irads
If you cannot power-up the computer without a display attached then this is not a normal behavior and you would better have your computer replaced - rma@fit-pc.com
If the problem is only after OS is loaded then check drivers.