Fit-PC2 Rev 1.21 and Sandisk SSD
Posted: Tue Oct 23, 2012 10:11 pm
Hello,
I just bought an used Fit-PC2.
The sticker on the PC has the serial number 090601-656 on it.
I assume that this is the hardware revision 1.21
I tried to install a SanDisk SSD (Type SanDisk SDSSDP-128G-G25 128GB (6,4 cm (2,5 inch), SATA III) but it failed.
The SSD was not detected and the installation of Windows 7 wasn't possible.
The original Samsung HDD worked fine so far.
Is there a known problem with new SSD controller from SanDisk?
I haven't had the chance to test the SSD in an other Computer (no SATA) but the disk is brand new.
Best regards
Michael
I just bought an used Fit-PC2.
The sticker on the PC has the serial number 090601-656 on it.
I assume that this is the hardware revision 1.21
I tried to install a SanDisk SSD (Type SanDisk SDSSDP-128G-G25 128GB (6,4 cm (2,5 inch), SATA III) but it failed.
The SSD was not detected and the installation of Windows 7 wasn't possible.
The original Samsung HDD worked fine so far.
Is there a known problem with new SSD controller from SanDisk?
I haven't had the chance to test the SSD in an other Computer (no SATA) but the disk is brand new.
Best regards
Michael