Headless (no monitor) operation, can't set screen resolution
Posted: Tue Jun 07, 2011 2:24 pm
I'm trying to use my Fit-PC2i for a headless (no monitor) operation. I will only access the Fit-PC2i using remote access such as VNC.
However, the screen resolution is very very low (640x480, 4 bit colour) and this setting can't be changed. This causes the remote access can't be used to control the PC properly.
When I connect a monitor to the PC the monitor resolution is controlable and can be set to normal and the pc keeps this setting as long it is powered.
But, the setting unfortunately goes "back to normal" (low. res.) when the pc is restarted.
What is to be done?
- Removal of current driver and installation of 'headless no monitor driver?
If a solution is available please inform of how to perform.
Your help please.
Best regards
Peter
However, the screen resolution is very very low (640x480, 4 bit colour) and this setting can't be changed. This causes the remote access can't be used to control the PC properly.
When I connect a monitor to the PC the monitor resolution is controlable and can be set to normal and the pc keeps this setting as long it is powered.
But, the setting unfortunately goes "back to normal" (low. res.) when the pc is restarted.
What is to be done?
- Removal of current driver and installation of 'headless no monitor driver?
If a solution is available please inform of how to perform.
Your help please.
Best regards
Peter