How can I control GPIOs and I2C?

Issues specific to fit-PC2i
Post Reply
mbc28
Posts: 4
Joined: Thu May 27, 2010 3:49 pm

How can I control GPIOs and I2C?

Post by mbc28 »

Hello,
The fit-pc2 specifications says there is a connector with some GPIOs and I2C. How can I control them? Are there any drivers?

Thank you.

irads

Re: How can I control GPIOs and I2C?

Post by irads »

This is not supported with fit-PC2.
For commercial project check www.compulab.co.il for embedded alternatives.

mbc28
Posts: 4
Joined: Thu May 27, 2010 3:49 pm

Re: How can I control GPIOs and I2C?

Post by mbc28 »

Hi,
I've seen that in compulab website there are 2 alternatives, SBC-FITPC2 and CM-iAM + SBC-iAM.
SBC-FITPC2 has I2C and GPIOs available? or only CM-iAM has them available?

Thank you.

irads

Re: How can I control GPIOs and I2C?

Post by irads »

This forum cannot be used for supporting CompuLab embedded products.
Please contact CompuLab - sales@compulab.co.il

Post Reply

Return to “fit-PC2i hardware”