Hello,
The fit-pc2 specifications says there is a connector with some GPIOs and I2C. How can I control them? Are there any drivers?
Thank you.
How can I control GPIOs and I2C?
Re: How can I control GPIOs and I2C?
This is not supported with fit-PC2.
For commercial project check www.compulab.co.il for embedded alternatives.
For commercial project check www.compulab.co.il for embedded alternatives.
Re: How can I control GPIOs and I2C?
Hi,
I've seen that in compulab website there are 2 alternatives, SBC-FITPC2 and CM-iAM + SBC-iAM.
SBC-FITPC2 has I2C and GPIOs available? or only CM-iAM has them available?
Thank you.
I've seen that in compulab website there are 2 alternatives, SBC-FITPC2 and CM-iAM + SBC-iAM.
SBC-FITPC2 has I2C and GPIOs available? or only CM-iAM has them available?
Thank you.
Re: How can I control GPIOs and I2C?
This forum cannot be used for supporting CompuLab embedded products.
Please contact CompuLab - sales@compulab.co.il
Please contact CompuLab - sales@compulab.co.il