View unanswered posts | View active topics It is currently Thu Dec 12, 2019 12:29 am



Reply to topic  [ 2 posts ] 
 Configure VGA output for modern monitor 
Author Message

Joined: Tue Mar 20, 2012 8:15 pm
Posts: 1
Post Configure VGA output for modern monitor
Whenever I boot, about 10 seconds after the GRUB menu selection the Dell U2412M reports
Quote:
The current input timing is not supported by the monitor display. Please change your input timing to 1920x1200 @60Hz or any other monitor listed timing as per the monitor specifications

I've tried setting LCD device mode to 640x480, 800x600, and 1600x1200 (all of which are supported by the monitor, and always using LCD refresh rate 60 Hz), changing the LCD data width, upping the Geode LX graphics to 32 MB, and resetting the bios to the factory settings, but it always reports the same issue.

Is there anything else I can try? To be clear, I can see the startup messages just fine, and as far as I know there is no X server installed (Ctrl-Alt-F1 does nothing).


Tue Mar 20, 2012 8:28 pm
Profile
Site Admin

Joined: Thu Jun 02, 2011 1:13 pm
Posts: 1260
Post Re: Configure VGA output for modern monitor
If this is an X server issue, please try to use "vga=0x315" boot option. It should set the graphics to very basic mode

_________________
Gabriel Heifets

Fit-PC2/3/IntensePC support.


Thu Mar 22, 2012 5:36 am
Profile
Display posts from previous:  Sort by  
Reply to topic   [ 2 posts ] 

Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group.
Designed by STSoftware for PTF.