fit-PC Users Forum
https://www.fit-pc.com/forum/

Power management and display
https://www.fit-pc.com/forum/viewtopic.php?f=80&t=4863
Page 1 of 1

Author:  equitius [ Fri Mar 15, 2013 6:03 am ]
Post subject:  Power management and display

I took delivery of my new fitPC-3 this morning. Its a great little beast.

Reading the manual, there is the following note:

Working without a connected display automatically disables the graphics controller - saving power

I have no desire to save power as my fit is plugged into 240V mains power. I use my pc to run my astronomical equipment and have it set up to be slaved to a computer inside my house using RealVNC. As there is no monitor connected, will the graphics controller be disabled? If so, is there a way to overide this setting? As I am imaging with the fitPC, I need good graphics resolution on the controlling computer.

I can't find any setting in the graphics card driver, display or power management settings or anything obvious in the BIOS.

Pete

Author:  irads [ Sat Mar 16, 2013 7:52 pm ]
Post subject:  Re: Power management and display

We are not aware of a way to bypass DDC handshake in Windows 7.
You may consider something like this http://www.amazon.com/gp/aw/d/B0032FF7B ... 11&pi=SL75

Author:  gabrielh [ Mon Mar 18, 2013 11:58 am ]
Post subject:  Re: Power management and display

You can also try this solution offered by one of our valued users.

Page 1 of 1 All times are UTC
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/