Coming fully back up after power loss

Power discussions, CPU and case temperature
ilia
Posts: 15
Joined: Mon Jun 25, 2012 11:33 am

Re: Coming fully back up after power loss

Post by ilia »

Thanks.
I'll try this night.

Ilia.

ilia
Posts: 15
Joined: Mon Jun 25, 2012 11:33 am

Re: Coming fully back up after power loss

Post by ilia »

The problem does not reproduces right now :(
It looks that no amount of waiting in power-off causes by itself the FitPC3 to not start on power on.
The "AC Loss control setting" BIOS parameter is and always was in "Power ON" state.

Do you have some insight on the FitPC3' power regulator -
i.e. can you think on the power up/down scenario, which can cause it to not start automatically?
Our customer is very sensitive on the matter, as they need the FitPC to operate unattended where there is no human being close.

If there are matters you prefer to not disclose in the public forum, you can mail me personally at: ilia@embedded-solutions.co.il

Thanks a lot.
Ilia

gabrielh
Site Admin
Posts: 1260
Joined: Thu Jun 02, 2011 1:13 pm

Re: Coming fully back up after power loss

Post by gabrielh »

Sometimes connected peripheral devices might interfere with power up sequence leading to failure in booting on power resume.

Failure in boot on power resume may also be related to the specific fit-PC3 unit.

I suggest
1. Try to reproduce the problem with all peripherals connected.
2. Selectively disconnect peripherals and try to reproduce.

Please report about the findings. We will try to determine if the failure is transient or symptomatic, and if RMA is due.
Gabriel Heifets

Fit-PC2/3/IntensePC support.

Post Reply

Return to “Power and Heat”