Page 1 of 1

Machine build quality.

Posted: Fri Nov 20, 2015 3:24 pm
by mhwelsh
I tried to remove the RAM to gain access to the bios reset pins.
One RAM board strikes the fixing screw hole for the lid/hdd.

I was reluctant to file a few microns off for fear of filling the machine with filings.
Perhaps you could make this lug a little smaller.

martin welsh

Re: Machine build quality.

Posted: Mon Dec 07, 2015 4:20 pm
by mbirger
Can you please send a photo of what you mean. In general, we use standard SO-DIMM slots and memories.

Re: Machine build quality.

Posted: Thu Dec 17, 2015 4:19 pm
by mhwelsh
The lugs that I am refering to are the screwholes for the base plate.

They are incrementally so large that the Ram memory board has to be forced pass them to replace it in the motherboard.

I hope that that helps.

martin welsh

Re: Machine build quality.

Posted: Mon Dec 21, 2015 4:49 pm
by mbirger
You don't need to struggle with reseting the BIOS if following the guide:
http://fit-pc.com/wiki/index.php/Intens ... leshooting

Re: Machine build quality.

Posted: Tue Jan 05, 2016 6:59 am
by irads
One RAM board strikes the fixing screw hole for the lid/hdd.
The question would better refer to machine design quality.
It is confirmed that if you release the top-most SODIMM it will touch the HDD door screw lug. However SODIMM can be reliably pushed in the socket and pulled out at that angle.

Filing would not be a good idea.

Thanks for the feedback. We are doing our best to improve usability with each product generation.