FACE Modules:FM-SER

From fit-PC wiki
Revision as of 11:16, 8 September 2015 by Maxim (Talk | contribs)

Jump to: navigation, search

FM-SER Module

FM-SER FACE Module provide various serial connectivity solution and compatible with several Compulab systems. Refer to Compatibility Matrix for products fit.

Highlights

  • High performance UARTS
  • Asynchronous baud rates up to 15Mbps
  • 128-byte deep TX/RX FIFOs
  • Advanced FIFO fill management
  • RS232, RS485, RS422 operation
  • Programmable RS485 turn-around delay
  • 450 through 950 software compatibility
  • Two independent CAN bus controllers implement CAN V2.0B at rate of up to 1Mbps each
  • Isolated PHY with rated isolation voltage of 2.5 kV RMS
Connectivity Specifications
RS232 / RS485 / RS4221 6x RJ-11 jacks functioning as RS2322, as half3/full-duplex RS485 or RS422 serial ports;
CAN bus 2x RJ-45 jacks functioning as an isolated Controller Area Network (CAN) bus

Notes:

  1. The default standard can be configured by jumper E1. See section Serial Ports Configuration.
  2. FM-SER is classified as DTE (Data Terminal Equipment) in terms of RS232 standard definition.
  3. RS485 half-duplex mode requires special HW/SW adaptation


Block Diagram

FM-SER.png


Schematics

Layout

Mechanics

Assembly


SW Drivers