FAQ:IPC2

From fit-PC wiki
Revision as of 07:57, 11 June 2015 by Maxim (Talk | contribs) (Hardware)

Jump to: navigation, search

Hardware

Which power supplies can power the IPC2?

IPC2 bundle comes with external AC/DC wall power supply, providing unregulated 10–15Vdc input voltage range, 12Vdc nominal. However, any power supply able to supply ~60W from 12Vdc source will be fine.

What are power capabilities of IPC2 USB ports?

Each VBUS pair supplied via onboard power switch with current limit settings of 2.1A, meaning either each VBUS capable sourcing up to 1.05A in case two bus powered devices connected, or sourcing 2.1A in case single bus powered device connected.

IPC2 serial ports

IPC2 features three RS232 serial ports, one full signal set and two other 2-wire Tx/Rx signals only.

IPC2 serial ports 700x175.png

  • Port 1 (left): Serial 2-wire com port (SuperIO Controller)
  • Port 2 (middle): Serial 2-wire com port (Embedded Controller)
  • Port 3 (right): Serial full signal set com port (SuperIO Controller)


Operating notes:

  1. Operating system can be a factor. We recommend to test the ports under Linux Mint 17 or Windows 7
  2. The operation can be dependent on devices connected, as the ports are not identical
  3. The middle port operated by Embedded Controller which is part of Intel architecture and fully under Intel control. It might not support specific devices.
  4. Usually 2-wire serial interface uses very basic, relatively slow and not too immune communication but it is very simple to use. Not all devices can communicate via 2-wire serial interface.
  5. The most reliable RS232 serial communication is the one uses full signal set or at least 4-wire, data (Tx/Rx) and flow control signals (CTS/RTS).

Software

Links