Difference between revisions of "How to install mSATA SSD on FM-USB3 module"
From fit-PC wiki
Line 13: | Line 13: | ||
# Now you have full access to mSATA slot. Connect mSATA by gently pushing it into plastic latch. | # Now you have full access to mSATA slot. Connect mSATA by gently pushing it into plastic latch. | ||
# Assemble in the reverse order | # Assemble in the reverse order | ||
+ | |||
+ | |||
+ | [[category:products]] | ||
+ | [[category:IPC2 | IPC3]] |
Revision as of 16:35, 15 May 2017
Instructions on how to install (or replace) mSATA SSD on FM-USB3 Module
Notes
- IPC3 hardware revision 1.1 supports mSATA SSD on FM-USB3 only.
- IPC2 (all HW revisions) allow installation of mSATA drive on FM-USB3 in addition to onboard slot.
Instructions
- Open the service door (see Maintenance chapter in IPC3 Owner’s Manual).
- Remove the four screws on the bottom cover of the IPC3.
- Carefully remove the bottom cover.
- Remove the single screw that holds the FM-USB3 card.
- Carefully remove the FM-USB3 card in the computer.
- Now you have full access to mSATA slot. Connect mSATA by gently pushing it into plastic latch.
- Assemble in the reverse order