Difference between revisions of "How to install mSATA SSD on FM-USB3 module"

From fit-PC wiki
Jump to: navigation, search
 
(2 intermediate revisions by one other user not shown)
Line 1: Line 1:
Instructions on how to install (or replace) mSATA SSD on [[FACE Modules:FM-USB3|FM-USB3 Module]]<br>
+
* This application note instructs how to install or replace mSATA SSD on [[FACE Modules:FM-USB3|FM-USB3 Module]]<br>  
 
+
* This application note is applicable for the following models:
=== Notes ===
+
** IPC3 HW revisions later than 1.1 , adding an option to add mSATA SSD on FM-USB3 only.
* IPC3 hardware revision 1.1 supports mSATA SSD on FM-USB3 only.  
+
** IPC2 (all HW revisions) adding another mSATA on the FM-USB3 in addition to the on-board slot.
* IPC2 (all HW revisions) allow installation of mSATA drive on FM-USB3 in addition to onboard slot.
+
  
 
=== Instructions ===
 
=== Instructions ===
Line 13: Line 12:
 
# Now you have full access to mSATA slot. Connect mSATA by gently pushing it into plastic latch.
 
# Now you have full access to mSATA slot. Connect mSATA by gently pushing it into plastic latch.
 
# Assemble in the reverse order
 
# Assemble in the reverse order
 +
 +
 +
[[category:products]]
 +
[[category:IPC2]]
 +
[[category:IPC3]]

Latest revision as of 14:02, 8 October 2018

  • This application note instructs how to install or replace mSATA SSD on FM-USB3 Module
  • This application note is applicable for the following models:
    • IPC3 HW revisions later than 1.1 , adding an option to add mSATA SSD on FM-USB3 only.
    • IPC2 (all HW revisions) adding another mSATA on the FM-USB3 in addition to the on-board slot.

Instructions

  1. Open the service door (see Maintenance chapter in IPC3 Owner’s Manual).
  2. Remove the four screws on the bottom cover of the IPC3.
  3. Carefully remove the bottom cover.
  4. Remove the single screw that holds the FM-USB3 card.
  5. Carefully remove the FM-USB3 card in the computer.
  6. Now you have full access to mSATA slot. Connect mSATA by gently pushing it into plastic latch.
  7. Assemble in the reverse order