Difference between revisions of "Quick AMT Setup"
From fit-PC wiki
(7 intermediate revisions by 2 users not shown) | |||
Line 1: | Line 1: | ||
− | '''Quick AMT Setup | + | * This manual instructs how to configure Intel AMT. |
+ | * It applies to machine models: Intense PC | IPC2 | Airtop1. | ||
+ | |||
+ | '''Quick AMT Setup''' | ||
#Enter BIOS go to ADVANCED -> AMT Configuration and set "Enter Intel(R) MEBx Setup" to "Enabled" | #Enter BIOS go to ADVANCED -> AMT Configuration and set "Enter Intel(R) MEBx Setup" to "Enabled" | ||
Line 15: | Line 18: | ||
'''Usage''' | '''Usage''' | ||
− | + | *Connect AMT capable LAN port to a network: | |
− | + | **Airtop - LAN2 | |
− | + | **IPC2 - LAN1 | |
− | + | **Intense PC - LAN closer to the edge | |
− | + | *On the remote machine: | |
− | + | **Open browser and set address to http://''target IP address'':16992 when "target IP address" was set previously in the AMT setup | |
+ | **Press "Log On" and enter login/password -> "admin"/''password'' when "password" was set previously in the AMT setup | ||
+ | **Now all system information/status/remote management menus are accessible including remote power on/off | ||
+ | *For remote KVM use "VNC Viewer Plus": http://www.realvnc.com/products/viewerplus/ |
Latest revision as of 13:18, 21 May 2019
- This manual instructs how to configure Intel AMT.
- It applies to machine models: Intense PC | IPC2 | Airtop1.
Quick AMT Setup
- Enter BIOS go to ADVANCED -> AMT Configuration and set "Enter Intel(R) MEBx Setup" to "Enabled"
- Exit saving changes -> System will boot ( one time ) to MEBx AMT setup
- Enter "MEBx Login" -> using password "admin" and set the "Intel(R) ME New password " according with rules below
- At least 8 characters ( max32)
- At least one digit character(0-9)
- At least one 7-bit ASCII non alpha-numeric character(e.g.'!','$',';') , but excluding ':' ,',' and '""' characters
- At least one lower case letter ('a','b'...'z') and at least one upper case letter ('A' ,'B'...'Z')
- Enter "Intel(R) Standard Manageability Configuration" -> "Activate Network Access" and press "Y"
- Enter "Network Setup" -> "TCP/IP Settings" ->"Wired LAN IPV4 Configuration" -> "DHCP Mode" and set to "Disabled"
- Now set all IPs related settings and then press "ESC" four times - returning to main menu
- Press "MEBx Exit" and wait until reboot
- Unplug your system for 20-30s and then plug it back
Usage
- Connect AMT capable LAN port to a network:
- Airtop - LAN2
- IPC2 - LAN1
- Intense PC - LAN closer to the edge
- On the remote machine:
- Open browser and set address to http://target IP address:16992 when "target IP address" was set previously in the AMT setup
- Press "Log On" and enter login/password -> "admin"/password when "password" was set previously in the AMT setup
- Now all system information/status/remote management menus are accessible including remote power on/off
- For remote KVM use "VNC Viewer Plus": http://www.realvnc.com/products/viewerplus/